CONSTANT CURRENT LED DRIVER - DIMMABLE - SINGLE OUTPUT - 1400 mA - 40 W

output: "•†rated current: 1400 mA "•†operating voltage range: 15 - 29 V "•†current accuracy: 8.0 % "•†rated power: 40.6 W "•†ripple & noise (max): 3 Vp-p "•†no load output voltage: 34 V "•†setup time: 500 ms / 230 VAC at full load "†input: "•†voltage range: 180 - 295 VAC, 254 - 417 VDC "•†frequency range: 47 - 63 Hz "•†power factor: PF > 0.95 / 230 VAC, PF > 0.9 / 277 VAC (at full load) "•†total harmonic: THD < 20% when output loading > 60% at 230 VAC input and output loading > 75% at 277 VAC input "•†efficiency: 86 % "•†AC current: 0.3 A/ 230 VAC, 0.25 A / 277 VAC "•†inrush current: cold start 15 A (twidth=50µs measured at 50% Ipeak) at 230 VAC "•†MAX. No. of PSUs on 16A circuit breaker: 47 units (circuit breaker of type B) / 47 units (circuit breaker of type C) at 230 VAC "•†leakage current: < 0.5 mA / 240 VAC "†protection: "•†short circuit: hiccup mode, recovers automatically after fault condition is removed "•†over temperature: hiccup mode, recovers automatically after temperature goes down "†environment: "•†working temperature: -30 - +40 °C "•†working humidity: 20 - 95% RH non-condensing "•†storage temperature, humidity: -40 - +80 °C, 10 - 95% RH "•†temperature coefficient: ±0.06% / °C (0 - 40 °C) "•†vibration: 10 - 500Hz, 2G 10min. / 1cycle, period for 60min. each along X, Y, Z axes "†safety & EMC: "•†safety standards: UL8750, CSA C22.2 No. 250.13-12, ENEC EN61347-1, EN61347-2-13, EN62384, GB19510.14,GB19510.1),IP30 approved "•†withstand voltage: I/P-O/P:3.75K VAC "•†isolation resistance: I/P-O/P:100M Ohms / 500 VDC / 25 °C / 70% RH "•†EMC emission: compliance to EN55015, GB17743, GB17625.1,EN61000-3-2 Class C(> 75% load),EN61000-3-3 "•†EMC immunity: compliance to EN61000-4-2,3,4,5,6,8,11,EN61547, light industry level, criteria B(surge 2KV) "†others: "•†MTBF: 822.7K hrs min. MIL-HDBK-217F (25 °C) "•†dimensions: 175 x 42 x 24 mm (L x W x H)
230 VAC only or full range (up to 295 VAC) models available "†built-in active PFC function "†constant current design "†protections: short circuit "†cooling by free air convection "†fully isolated plastic case "†class II power unit, no FG "†no load power consumption <0.5W "†high reliability, low cost